SINGER 6212 - Manual (Page 34)

CHANGING THE LIGHT BULB
Before changing light bulb, make sure you have disconnected pOwer-line plug and
remove face plate which covers the light bulb.
This machine is designed to use a
15-watt maximum light bulb with a
locking pin base.
• Loosen and remove screw (1)
located on face plate.
• Remove face plate by grasping it
around the bottom edge and pulling
toward the left, then down and away
from machine.
• Do not attempt to unscrew light bulb.
• Push bulb up Into socket and turn in
the direction of arrows to unlock bulb
pin.
• Pull bulb down and out of socket.
• Push new bulb up into socket and
turn in the direction of arrows until
pins lock into position.
• Making sure the presser foot lifter is
up, replace the face plate by guiding
front top corner under and behind
lowest front corner of top cover.
Push bottom of face plate up and
back until it is aligned with top cover.
• Insert screw and tighten.
CLEANING THE MACHINE
Your machine is designed to give you many years of dependable service. To ensure
this reliability, take a few minutes to keep the machine clean.
The machine surfaces and covers
can be cleaned when necessary, with
a damp, soft cloth and a mild soap.
Remove lint and fluff from exposed
parts and, with a soft cloth, clean these
parts:
• Tension discs.
• Take-up lever and thread guides.
• Presser and needle bars.