5 installation checklist, Date of installation, Name of installer – Generac Power Systems 009600-4 User Manual

Page 38: Signature of installer, Installation checklist, Cooling and ventilating ali, Gasoline fuel system, Optional accls

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

INSTALLATION

Section 7 - Post Installation

PRIMEPACT 66G and 66LP Recreational Vehicle Cenerators

7.5

INSTALLATION

CHECKLIST

♦ LOCATION AND SUPPORT

l

J Generator is properly located.

U Generator is properly supported.

□ Generator is properly restrained.

♦ GENERATOR COMPARTMENT

□ Coiiipartment construction is proper.

U Holes/Openings are vapror-sealed.

□ Compartment size is correct.

□ Compartment is vapor-sealed.

□ Sound insulation is correct.

□ Floor cutouts are properly completed.

♦ COOLING AND VENTiLATiNG Ali

U Airflow is adequate.

J Air inlet opening is correct.

U Compensate for restrictions.

U Check that installation has been tested.

♦ GASOLINE FUEL SYSTEM

LJ Fuel tank complies with all af)plicable codes.

□ Fuel system is properly installed and checked

for leaks.

♦ OPTIONAL LP GAS

FUEL SYSTEM

□ Fuel system is properly installed and checked

for leaks.

□ Pressure at regulator inlet is correct.

□ Rated flow of primary regulator is correct.

□ All parts are properly installed,

□ Fuel system is properly tested/adjusted.

♦ EXHAUST SYSTEM

□ Exhaust system complies with all applicable codes.

□ Exhaust system is properly and safely installed.

♦ ELECTRICAL CONNECTIONS

□ Connections comply with local code requirements

and all National Electrical Codes.

□ Junction box is properly installed.

□ Wiring meets all standards.

□ All connections are correct.

□ Conduit is properly installed and sealed.

□ Generator is properly bonded to the veliicle.

♦ BATTERY INSTALLATION

□ Recommended battery is installed,

□ Recommended cables are iiistalied.

□ Cables are clean and light.

□ Cables are connected properly.

□ Proper ventilation is proCded.

□ Terminal'’ arp coaled wiib anti-corrosion grease, and

terminal coi' t n< po~,>i'.uied.

♦ OPTIONAL ACCLS

j

ORI

e

S

□ Check that remote start/stop panels (if used) are

installed properly.

□ Check that hour meter kit (if used) is installed

properly.

□ Check that any other options and accessories (if

used) are installed properly.

# POST INSTALLATION TESTS

□ Check that all tests are completed properly.

DATE OF INSTALLATION

NAME OF INSTALLER

SIGNATURE OF INSTALLER

36 Generac* Power Systems, Inc.

Advertising
This manual is related to the following products: