Bowflex Xtreme 2 SE - Manual (Page 13)

Bowflex Xtreme ® 2 SE Assembly Manual 9
step 7 Install Slider Pulleys
Parts:
• 2 Slider Pulleys w/ Decal
• Main Assembly
tools: 3/16 Hex Wrench
7-1 Install a Slider Pulley onto each Pulley Arm as
shown .
7-2 Choose any of the four holes to secure .
Slider Pulley w/ Cable
Assembly
Slider Pulley w/ Cable
Assembly
Flat Washer
Threaded Stud
Nylock Nut
Nylock Nut
Flat Washer
Assembly Guide
step 6 Install Pulley Arms
Parts:
• Right Pulley Arm
• Left Pulley Arm
• Main Assembly
Hardware:
• 4 Washers (3/8")
• 4 Button Head Screws (3/8" X 3/4")
• 2 Threaded Studs (1/2" X 9 1/2")
• 4 Nylock Nuts (1/2")
• 4 Washers (1/2")
tools: 7/32" Hex Wrench, Rubber Mallet
6-1 Slide Left and Right Pulley Arms onto
the connectors on the base frame as
shown .
6-2 Secure Pulley Arms to Base Frame
using 3/8” screws and washers as
shown .
finger tighten screws
at this time.
6-3
Align the two holes in the Pulley Arms with those
in the Lower Lat Tower Assembly and secure
using threaded studs, 1/2” washers and nuts as
shown .
Left Pulley Arm
Right Pulley Arm
Base Frame &
Lower Lat Tower
Assembly
Flat Washer
Button Head
Screw