Assembly guide – Bowflex Xtreme 2 SE User Manual

Page 21

Advertising
background image

Bowflex Xtreme

®

2 SE Assembly Manual

17

Assembly Guide

step 18 Cable and Pulley Routing – Connect Pulleys and Cables to the Lat Pulley

Housing

Locate the following items for the Lat Pulley Housing assembly:
• (2) Pulleys from step 17
• 3/8” X 4 1/2” Hex Head Bolt – uninstalled in Step 17

• 3/8” Washer – uninstalled in Step 17

note:

Connecting the Cables is much easier with a second persn assisting you .

18-1

Holding both Cables from Step 17 in place, align the 2 Lat Pulleys as shown in Figure 18 . Slide the Pulleys

back into the Lat Pulley Housing, lining up the bolt holes in the Pulleys and Lat Pulley Housing.

18-2

Place the Washer over the 4 1/2” Bolt from Step 17. Slide the Bolt through the aligned holes in the Lat Pulley

Housing and Lat Pulleys as shown in Figure 18 .

tighten all hardware.

note:

You will probably need to push the Power Rod

®

unit out of the way for this step. The Power Rod

®

unit is

not pictured for the sake of clarity.

2

2

1

1

Advertising