Bowflex Xtreme 2 SE - Manual (Page 17)

Bowflex Xtreme ® 2 SE Assembly Manual 13
step 14 Ab Crunch Station Assembly
Parts:
• Ab Crunch Bracket
• Ab Cross Bar
Hardware (1:1):
• 2 Button Head Screws (3/8" X 2 3/4")
• 4 Washers (3/8")
• 2 Nylock Nuts 3/8 -16
tool: 7/32" Hex Wrench
14-1 Attach the Ab Cross Bar to the Ab Crunch
Bracket as shown. Tighten all hardware. from
this step .
Assembly Guide
Ab Bracket
Ab Lat Cross Bar
Flat Washer
Lock Nut
Button Head Screw
step 13 Upper Lat Tower Assembly
Parts:
• Upper Lat Tower
• Lat Cross Bar
• Rear Lat Crossmember
Hardware:
• 2 Button Head Screws (3/8" X 3")
• 2 Washers (3/8")
• 2 Nylock Nuts (3/8”)
• 2 Button Head Screws (1/2" X 5 1/4")
• 2 Wide Washers (1/2")
• 2 Nylock Nuts (1/2”)
tool: 7/32" Hex Wrench and Adjustable Wrench
13-1 Align the two holes on the Lat Cross Bar with those
on the Upper Lat Tower as shown.
13-2 Attach using 3/8” screws, washers and nuts as
shown .
Note: Do not tighten hardware at this time.
13-3 Align the bracket on the Rear Lat Crossmember with
the bolt on the Upper Lat Tower as shown.
13-4 Attach using 1/2” screws, washers and nuts as
shown .
13-5 Tighten all hardware from this step.
3/8" Button
Head Screw
3/8" Washer
Lat Cross Bar
Upper Lat
Tower
3/8" Nut
1/2"
Washer
1/2" Button
Head Screw
1/2" Nut