Cisco 2900 SERIES XL - Manual (Page 52)

Chapter 2 Installation
Installing the Switch in a Rack
2-10
Catalyst 2900 Series XL Hardware Installation Guide
78-6461-03
To install the switch in a 19-, 23- or 24-inch standard rack, follow the instructions
described in these procedures:
• “Removing Screws from the Switch” section on page 2-10
• “Attaching the Brackets to a Catalyst 2912 XL, 2924C XL, 2924 XL, 2912MF
XL, or 2924M XL Switch” section on page 2-11
• “Attaching the Brackets to a Catalyst 2912 LRE XL or 2924 LRE XL Switch”
section on page 2-17
• “Mounting the Switch in a Rack” section on page 2-19
• “Attaching the Optional Cable Guide” section on page 2-20
Removing Screws from the Switch
If you plan to install the switch in a rack, you must first remove screws in the
switch chassis so that mounting brackets can be attached.
Figure 2-3 shows how
to remove the chassis screws in a fixed-port and a modular port switch.
Figure 2-3 Removing Screws from the Switch
47292
22X 22X 23X 24X
SERIES
Catalyst 2
900
XL
Fixed-port
Catalyst 2900 series XL
Modular
Catalyst 2900 series XL
SERIES
Catalyst 2
900
XL