Cisco 15600 User Manual

Page 23

Advertising
background image

17-23

Cisco ONS 15600 Procedure Guide, R8.0

Chapter 17 DLPs E100 to E199

DLP- E126 Provision the IIOP Listener Port on the CTC Computer

•

Other Constant—If Port 683 is not used, type the IIOP port specified by your firewall administrator.

Step 3

Click Apply.

Step 4

When the Change Network Configuration message appears, click Yes.

Both Timing and Shelf controllers (TSCs) reboot, one at a time. The reboot will take approximately
15 minutes.

Step 5

Return to your originating procedure (NTP).

DLP-E126 Provision the IIOP Listener Port on the CTC Computer

Step 1

From the Edit menu, choose Preferences.

Step 2

In the Preferences dialog box, click the Firewall tab.

Step 3

In the CTC CORBA (IIOP) Listener Port area, choose a listener port option:

•

Default - Variable—Use to connect to ONS 15600s from within a firewall or if no firewall is used
(default).

•

Standard Constant—Use Port 683, the CORBA default port number.

•

Other Constant—If Port 683 is not used, enter the IIOP port defined by your administrator.

Step 4

Click Apply. A warning appears telling you that the port change will apply during the next CTC login.

Step 5

Click OK.

Step 6

In the Preferences dialog box, click OK.

Step 7

To access the ONS 15600 using the IIOP port, log out of CTC then log back in. (To log out, choose Exit
from the File menu.)

Step 8

Return to your originating procedure (NTP).

Purpose

This task selects the IIOP listener port on CTC.

Tools/Equipment

IIOP listener port number from LAN or firewall administrator

Prerequisite Procedures

NTP-E21 Verify Card Installation, page 4-2

DLP-E26 Log into CTC, page 16-33

Required/As Needed

Required only if the computer running CTC resides behind a firewall

Onsite/Remote

Onsite or remote

Security Level

Provisioning or higher

Advertising