Cisco 15600 - Manual (Page 53)

17-53
Cisco ONS 15600 Procedure Guide, R8.0
Chapter 17 DLPs E100 to E199
DLP- E167 Clear a Manual or Force Switch in a 1+1 Protection Group
Step 6 Complete the “NTP-E11 Install the OC-N Cards” procedure on page 2-4 .
Step 7 Return to your originating procedure (NTP).
DLP-E167 Clear a Manual or Force Switch in a 1+1 Protection Group
Step 1 In node view, click the Maintenance > Protection tabs.
Step 2 In the Protection Groups area, choose the protection group that contains the card you want to clear.
Step 3 In the Selected Group area, choose the card you want to clear.
Step 4 In the Inhibit Switching area, click Clear.
Step 5 Click Yes in the confirmation dialog box.
The Manual or Force switch is cleared.
Step 6 Return to your originating procedure (NTP).
DLP-E168 Clear a Lock On or Lockout in a 1+1 Protection Group
Step 1 In node view, click the Maintenance > Protection tabs.
Purpose For ports configured for revertive switching, this task clears the Manual
or Force switch and restores traffic to the pre-switch port. For
nonrevertive ports, it clears the switch but does not revert traffic to the
previous port.
Tools/Equipment None
Prerequisite Procedures DLP-E99 Initiate a Manual Switch on a Port in a 1+1 Protection Group,
page 16-93
or
DLP-E100 Initiate a Force Switch on a Port in a 1+1 Protection Group,
page 17-1
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Purpose This task clears the lock on or lockout to resume normal protection
switching capability.
Tools/Equipment None
Prerequisite Procedures DLP-E101 Apply a Lock On in a 1+1 Group, page 17-2 or
DLP-E102 Apply a Lockout in a 1+1 Group, page 17-3
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher