Cisco 15600 - Manual (Page 43)

17-43
Cisco ONS 15600 Procedure Guide, R8.0
Chapter 17 DLPs E100 to E199
DLP- E154 Delete Alarm Severity Profiles
Step 3 Click Apply and OK.
Note Setting the Maximum History Entries value to the high end of the range uses more CTC memory
and could impair CTC performance.
Note This task changes the maximum history entries recorded for CTC sessions. It does not affect the
maximum number of history entries viewable for a network, node, or card.
Step 4 Return to your originating procedure (NTP).
DLP-E154 Delete Alarm Severity Profiles
Step 1 From the View menu, choose Go to Network View.
Step 2 Click the Provisioning > Alarm Profiles > Alarm Profile Editor tabs.
Step 3 Click the column heading for the profile column you want to delete.
The selected alarm profile name appears in the Description field.
Step 4 Click Delete.
The Select Node/Profile Combination for Delete dialog box appears.
Step 5 Click the node name(s) in the Node Names list to highlight the profile location.
Tip If you hold the Shift key down, you can select consecutive node names. If you hold the Ctrl key
down, you can select any combination of nodes.
Step 6 Click the profile name(s) that you want to delete in the Profile Names list.
Step 7 Click OK.
The Delete Alarm Profile confirmation dialog box appears.
Step 8 Click Yes for each Delete Alarm Profile confirmation dialog box.
Note If you delete a profile from a node, it is still displayed in the network view
Provisioning > Alarm Profiles > Alarm Profile Editor window unless you remove it by choosing
Remove.
Purpose This task deletes a custom or default alarm severity profile.
Tools/Equipment None
Prerequisite Procedures DLP-E26 Log into CTC, page 16-33
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher