Dlp-e157 disable alarm filtering – Cisco 15600 User Manual

Page 47

Advertising
background image

17-47

Cisco ONS 15600 Procedure Guide, R8.0

Chapter 17 DLPs E100 to E199

DLP- E157 Disable Alarm Filtering

DLP-E157 Disable Alarm Filtering

Step 1

In the node, network, or card view, click the Alarms tab.

Step 2

Click the Filter tool at the lower-right side of the bottom toolbar.

Alarm filtering is enabled if the tool is selected and disabled if the tool is raised (not selected).

Step 3

If you want alarm filtering disabled when you view conditions, click the Conditions tab and repeat

Step 2

.

Step 4

If you want alarm filtering disabled when you view alarm history, click the History tab and repeat

Step 2

.

Step 5

Return to your originating procedure (NTP).

DLP-E158 Manually Lock or Unlock a User on a Single Node

Step 1

In node view, click the Provisioning > Security > Users tabs.

Step 2

Choose the user you want to lock out.

Step 3

Click Change.

Step 4

Complete one of the following:

•

To lock a user out so the user cannot log into the node, check the Locked out check box.

•

If the user is currently locked out, uncheck the Locked out check box.

See the

“DLP-E130 Change Security Policy on a Single Node” task on page 17-26

for more

information about manual lockouts and lockout duration.

Step 5

Click OK. A confirmation dialog box appears.

Purpose

This task turns off specialized alarm filtering in all network nodes so that
all severities are reported in CTC.

Tools/Equipment

None

Prerequisite Procedures

DLP-E155 Enable Alarm Filtering, page 17-44

DLP-E26 Log into CTC, page 16-33

Required/As Needed

As needed

Onsite/Remote

Onsite or remote

Security Level

Retrieve or higher

Purpose

This task manually locks out or unlocks a user from a single node.

Tools/Equipment

None

Prerequisite Procedures

DLP-E26 Log into CTC, page 16-33

Required/As Needed

As needed

Onsite/Remote

Onsite or remote

Security Level

Superuser

Advertising