Clean your unit during regular use – NewAir AI-400 Series User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CLEAN YOUR UNIT DURING REGULAR USE
After you have used your unit for three or more months, we suggest cleaning the unit again.
Unplug your unit before doing any cleaning or maintenance!
•
For the outside enclosure of the unit, wash with a soft, wet cloth and liquid dishwashing soap.
Do not use corrosive chemical solvents as this might cause color changes and hurt the
machine. Do not pour water over the whole shell when washing, and avoid getting the
electrical parts wet.
•
For the hot and cold water dispenser, twist the bottle receptacle of the non-spill system (smart
device) counterclockwise and pull it up.
Take apart the non-spill system (smart device and smart core showed in above figure), and
proceed to wash it with the dishwashing fluid, rinse, and reassemble. Empty both tanks (hot and
cold) by unplugging the drain cap of the hot water tank at the back of the unit. Next, clean the
inside parts of the water dispenser system with vinegar or a 2% citric acid solution to remove
mineral scaling from the water. Rinse well, and then open the drain cap from the hot water tank to
remove all of the water. Replace all of the parts and securely fasten the drain cap. It is
important to let the unit dry for two hours before plugging it back in. When finished, reinstall the
bottle receptacle (smart device).
•
• For the ice-making chamber, remove the ice and water separator and the ice storing plate by
unscrewing the screw according to the following figure.
11