NewAir AI-400 Series - Manual (Page 7)

Begin Operation
UNPACKING THE UNIT
• Removing the package: Do not turn the unit upside down or lay it on its side.
a. Remove the strap.
b. Open the carton box.
c. Remove the Styrofoam packing from the box.
d. Pull the unit straight up from the box.
e. Remove the plastic bag.
The refrigeration compressor has sensitive mounts inside
of the welded shell for quiet operation.
Improper handling may damage the compressor.
• Wipe clean if necessary.
• Place the unit evenly and gently on a hard and flat surface.
The location should not be directly in the sunlight or another
source of heat.
• Place the unit where it will receive proper air circulation, and
make sure that there is at least 2 inches between the back of
the unit and the wall. Keep a minimum distance of 4 inches
between each side of the unit.
• The appliance must be positioned so that the plug is accessible.
• Fasten the drain cap tightly on the back of the unit before running, as during the shipping
process, it may be loose. If it is not fastened properly, water leakage may occur.
• Do not plug the power cord into the power socket before further reading instructions!
This unit is for indoor use only.
Room temperature should not exceed 97 Degrees F/36 Degrees C.
CLEAN BEFORE USING
Before using your unit, it is strongly recommended that it is cleaned thoroughly.
1. Take out the accessory ice shovel from the ice-making chamber.
2. The outside of the unit should be cleaned regularly with a mild detergent solution and warm
water.
3. For the first time, hold the clean water bottle vertically and upside down (over the smart device)
and place the water bottle into the smart device receptacle. After a few minutes, water will
flow into all of the faucets, and the cold and hot water tank, until the water is able to flow from
the faucet. Then, take down the water bottle and open the drain cap for the hot tank. Let all
of the water flow out and then reinstall the drain cap and tighten it.
5