Aiwa Z-L70 - Manual (Page 24)

To add a reservation during piay
Repeat step 3.
To check the reserved tracks
Press CD EDiT/CHECK repeatedly. Each time it is pressed, the
disc number and track number are displayed in the reserved
order.
To stop piay
Press ■. When ◄►is pressed, the play starts from the last
track again.
To skip a track
Press ►►.
The skipped track is cleared from the program.
To ciear aii the reservations
In stop mode, press ►► repeatedly until “K - POO” is displayed.
■■■ ...........
I___
/ /
/ LATMf
_____ _______
P'ia®
-...'-Ml
Press it once more to cancel the Karaoke programs. The display
returns to that of CD play.
NOTE
' If the reserved track number does not exist on the selected
disc, the unit stops playing and the display flashes.
In this case, press ►► to skip the error track. Then press ◄►
to start play with the next reserved track.
■ When PRGM is pressed twice in step 2, - 0:00” is displayed
and the unit enters CD programmed play mode (page 17).
To cancel programmed play, press ■.
CLOCK AND TIMER
SETTING THE CLOCK
1
-CLOCK
When the clock is set, the between the hours and minutes
flashes. When the power cord Is plugged into an AC outlet for
the first time after purchase or when the clock setting is canceled
due to a power failure, the entire clock display flashes.
1 Press CLOCK.
Htn 2 ^ -
2 Within 4 seconds, turn MULTI JOG to designate
the hour and the minute.
Turning MULTI JOG changes both the hour and the minute.
◄◄ or ►► is also available instead of MULTI JOG. Holding
these buttons down will vary the time rapidly.
3 Press ENTER or I I .
The clock starts from 00 seconds.
To view the clock when another display is in the display
Press CLOCK. The time is displayed for 4 seconds and then the
original display reappears. However, the clock cannot be
displayed during recording.
To switch to the 24-hour standard
Press CLOCK and then press ■ within 4 seconds.
Repeat the same procedure to restore the 12-hour standard.
If the clock display flashes
If the display flashes when the clock is displayed, it indicates
that the clock has stopped due to a power failure or the
removal of the power cord. The current time needs to be reset.
If the power-economizing mode (page 7) is on, all the display
lights turn off when the power is turned off. To view the clock,
press CLOCK so that the time is displayed for 4 seconds.
24
ENOLISH