Dish Network SoloDVR ViP 612 - Manual (Page 70)

Remote Control Setup
65
Improving Receiver Control
Installing a UHF Attenuator
Unwanted UHF signals may interfere with signals from the remote control to the receiver.
To prevent such interference, you can install an F-connector attenuator between 6dB and
15dB. Attenuators are available from many consumer electronics parts stores. Adding this
attenuator will help reduce interference from other devices, but it also cuts down how far
away you can use the remote control.
1
Remove the remote control antenna
from the R
EMOTE A NTENNA input on
the receiver back panel.
2
Attach an attenuator (between 6dB
and 15dB) to the R
EMOTE A NTENNA
input.
3
Attach the remote control antenna to
the attenuator.