Connections, Standard-definition connections – Dish Network SoloDVR ViP 612 User Manual
Page 94
Connections
89
Connecting to the TV
Standard-Definition Connections
1
Connect the receiver to the TV using one of the following:
•
A
UDIO
/V
IDEO
connection (RCA-type composite connection)
•
S-V
IDEO
and L
EFT
/R
IGHT
A
UDIO
•
TV S
ET
O
UT
2
If using the TV S
ET
O
UT
connection, peel off the white sticker and attach it to the cable
close to where it connects to the TV S
ET
O
UT
connection on the back of the receiver. The
sticker is in the front cover of this guide.
3
Turn on the TV and receiver to make sure you have a picture.
•
If using the TV S
ET
O
UT
connection, you’ll need to set your TV to either channel 3 or 4.
This output channel can be changed in the receiver’s menus by pressing MENU on
the remote control, selecting System Setup, Installation, then Modulator Setup.
The default output is channel 3.
•
If using the S-V
IDEO
or A
UDIO
/V
IDEO
connections, you’ll need to set your TV to a video
input or source. Refer to your TV’s user guide for more information.
4
Turn up the volume on the TV to make sure you have audio.