Dish Network SoloDVR ViP 612 - Manual (Page 73)

68
Operating Other Devices
Chapter 10
Setting Up Using Device Codes Scan
If the code for your device is not listed in the tables starting on page 112, use this
procedure to scan the remote control’s memory for the device code. In the instructions
below, the column on the left contains the instructions and the column on the right
provides additional information.
10
If the code doesn’t work, repeat steps
3 through 9 with the next device code
from the tables. Try every code listed for your brand until one
works for your device.
11
If you can’t find a code that works try,
Setting Up Using Device Codes Scan
that follows.
Instructions Additional Information
1
Turn the device on. Use the device’s front panel buttons or its
remote control.
2
Press and hold the mode button until
all the other mode buttons light up,
and then let go of the button. The
mode button flashes. For example, hold TV for a TV until all of the
other mode buttons light. When you let go, TV
will flash.
3
For AUX mode only. Press 0 for a
TV, or 1 for a VCR, or 2 for a tuner, or
amplifier. Then press the STAR (*)
button. This step is for programming which kind of
device that should be programmed in AUX
mode. If you’re not programming in AUX mode,
skip to step 4.
4
Press POWER. This puts your remote in the scan mode.
Instructions Additional Information