Dish Network SoloDVR ViP 612 - Manual (Page 92)

Connections
87
Connecting to the TV
High-Definition Connection: YP B P R (Component) Cables
The YP B P R connections provide high-quality video to your HDTV or HD monitor. Use
these connections if your TV does not have an HDMI connection.
1
Connect component video cables to the YP B P R (component) connections on the receiver.
Connect the other end of the component video cables to the YPbPr (component) connec-
tions on the TV.
2
Connect audio (red and white) RCA-type cables between the receiver’s Audio Outputs
and TV’s audio inputs.
3
Turn on your receiver and TV. Change your TV to the correct input or source. Consult your
HDTV user’s guide for assistance.
4
If you do not see a picture, refer to No Picture on the TV, below.
5
Turn up the volume on your HDTV and confirm you have sound.
6
Refer to Setting Up to Display in HD on page 88, to adjust the receiver’s HD display
settings to match your TV.
No Picture on the TV
This section helps you display a picture on your TV if you were not able to using the
previous sections.
1
Connect RCA-type cables between the receiver’s C OMPOSITE (RCA-type) video output
and your TV’s Composite (RCA-type) input.
2
Verify the receiver and the TV are on.
3
Make sure the TV is set to the correct input for the RCA-type connection. Refer to your
HDTV user’s guide for assistance.
4
Change the HDTV settings to match your TV’s display settings as described on page 88.
5
Change the TV to display from the HD input you connected in the previous sections. If you
can see a picture, you are finished.
6
Repeat steps 4 and 5 until the TV displays video from the receiver.
1
3
4
Connect receiver
and monitor with
YPbPr Component
connections
Turn monitor
and receiver on
and confirm
picture
Confirm
sound and
volume
2
Connect receiver
and monitor with
Audio cables
AUDIO
L
R