Fireplace installation – Desa (V)T32EN SERIES User Manual

Page 23

Advertising
background image

www.desatech.com

111987-01D

3

REMOvING/REpLACING GLASS
DOOR

CAUTION: Do not operate

this fireplace with a broken glass

door panel or without the glass

door panel securely in place.

For replacement part informa-

tion see Replacement Parts,

page 38.

CAUTION: Wear gloves and

safety glasses while handling

or removing broken glass. Do

not remove if glass is hot. Keep

children and pets away from

glass.

WARNING: If fireplace has

been running, turn off and un-

plug fireplace. Let cool before re-

moving glass door or louvers.

Removing Louver Panels

Remove the top and bottom louver panels by si-

multaneously pulling both top end spring latches

towards the center of the appliance until they are

disengaged from the locating holes (see Figure 37).

Repeat for bottom spring latches and pull the lou-

vers outward. To install or replace items removed,

simply reverse the procedures above.

FIREPLACE

INSTALLATION

Continued

Removing Glass Door

If replacement of glass is necessary, the entire

assembly, glass and frame, must be replaced. If

glass is broken, wear gloves and tape the remaining

fragments onto the frame.

1. Remove screen assembly by pushing the rod

either left or right and then down and forward

to remove screen/rod assembly from the fire-

box. Set assembly aside.

2. Lift up on latches to unlock. There are two on

top of firebox and two below firebox that hold

glass door in place (see Figure 38).

3. While holding glass door to prevent it from

falling and causing injury, remove the five

screws from the hinge located on the left side

of door frame assembly (see Figure 38).

4. Remount the new frame at the hinge with five

new screws before closing door. This will

ensure seating of the gasket.

5. Close glass door frame. Lock latches by placing

the bar under the tab on door and pushing down

and back on latch (see Figure 38).

6. Replace screen/rod assembly by reversing step 1.

7. Replace louvers by reversing procedure under

Removing Louver Panels.

Figure 37 - Removing Louver Panel

Louver Panel

Spring
Latch

Lock

Unlock

Glass
Frame
Assembly

Screw

Figure 38 - Removing/Replacing Glass

Door

Hinge

Latch

Cleaning Glass Door

See Cleaning and Maintenance on page 30.

Advertising