Local codes, Product identification, Product features – Desa (V)T32EN SERIES User Manual

Page 4: Safety information, Product identification product features

Advertising
background image

www.desatech.com

111987-01D

4

SAFETy INFORMATION

Continued

2. If you smell gas

• shut off gas supply

• do not try to light any appliance

• do not touch any electrical switch; do not use

any phone in your building

• immediately call your gas supplier from a

neighbor’s phone. Follow the gas supplier's

instructions

• if you cannot reach you gas supplier, call the

fire department.

3. Never install the fireplace

• in a recreational vehicle

• in windy or drafty areas where curtains or

other combustible (flammable) objects can

make contact with the fireplace front

• in high traffic areas

4. Turn appliance off and let cool before servic-

ing, installing or repairing. Only a qualified

service person should install, service or repair

this fireplace. Have fireplace inspected annu-

ally by a qualified service person.

5. You must keep control compartments, burn-

ers and circulating air passages clean. More

frequent cleaning may be needed due to ex-

cessive lint and dust from carpeting, bedding

material, etc. Turn off the gas valve and pilot

light before cleaning fireplace.

6. Have venting system inspected annually by

a qualified service person. If needed, have

venting system cleaned or repaired.

7. Do not use any solid fuels (wood, coal, paper,

cardboard, etc.) in this fireplace.

8. This appliance, when installed, must be electri-

cally grounded in accordance with local codes

or, in the absence of local codes, with the

National Electrical Code, ANSI/NFPA 70 or

the Canadian Electrical Code, CSA C22.1.

9. Do not use fireplace if any part has been ex-

posed to or under water. Immediately call a

qualified service person to arrange for replace-

ment of the unit.

10. Do not operate fireplace if any log is broken.

11. Do not operate fireplace with glass door

removed, cracked or broken.

12. Provide adequate clearances around air

openings.

Figure 1 - Direct-Vent Fireplace

Glass Door
Assembly

ON/OFF/REMOTE Switch
(Optional Installation)

Upper Louver
Panel

Lower
Louver
Panel

Flue Collar

Nailing
Flange

LOCAL CODES

Install and use fireplace with care. Follow all local

codes. In the absence to local codes, use the cur-

rent National Fuel Gas Code ANSI Z223.1/NFPA

54* (USA) or the current CSA-B149.1 Installation

Code (Canada).

*Available from:

American National Standards Institute, Inc.

1430 Broadway

New York, NY 10018

National Fire Protection Association, Inc.

Batterymarch Park

Quincy, MA 02269

PRODUCT

IDENTIFICATION

PRODUCT FEATURES

These are a few facts that can help you understand

and enjoy your direct-vent fireplace:

• The venting system may be routed to the outside

of your home in several ways. It may vent through

the roof (vertical) or it may vent to an outside/exte-

rior wall (horizontal). The vent pipe installation is

very important to allow for proper operation. You

must follow the venting instructions very carefully

for either vertical or horizontal applications.

• This fireplace may be installed in any room of

your house provided all local codes and these

installation instructions are followed.

Control
Valve

Glowing
Embers

Blower Switch
(Optional
Installation)

Grate
Assembly

Lava Rock

Log Set

Advertising