Desa (V)T32EN-A Series - Manual (Page 21)

21
21
www.desatech.com 116647-01A
FIREPLACE INSTALLATION
Continued
FIREPLACE INSTALLATION
Installing Optional Brick Liner Model BL32D
Installing Logs, Lava Rock and Glowing Embers
INSTALLING OPTIONAL BRICK LINER
MODEL BL32D
WARNING: If fireplace has been running, turn
off and unplug fireplace. Let cool before installing
brick liner.
This brick liner kit is optional. You may purchase brick liner from
your local retailer or see page 37.
CAUTION: Always handle brick panels with two
hands. Do not force brick panels into place. Exces-
sive force will break brick panels.
1. Remove top and bottom louvers to allow access to door latches.
2. Unlock door latches and open glass door. See steps 1 and 2 of
Removing/Replacing Glass Door, page 20.
3. If installing brick liner in new fireplace, go to step 4. If install-
ing brick liner in an existing fireplace, carefully remove logs,
lava rock and ember material.
4. Remove three screws from deflector shield on the inside top
of firebox. Set shield and screws aside.
5. Install rear brick panel first. Rest bottom edge of panel on back
edge of grate (see Figure 38).
6. Install left side brick panel by sliding it between the grate and
the side of the firebox (see Figure 39).
7. Install the right brick panel using the same method described
8. Replace deflector shield using screws removed in step 4.
9. Follow instructions beginning in column 2 to install logs, lava
rock and ember material.
Figure 38 - Installing Rear Brick Panel
Rear Brick
Panel
Figure 39 - Installing Side Brick Panels
Left Side
Brick Panel
10. Close glass door, lock latches on top and bottom of door and
replace screen (see steps 5 and 6 of Removing Glass Door,
page 20).
11. Close top and bottom louvers.
INSTALLING LOGS, LAVA ROCK AND
GLOWING EMBERS
Each log is marked with a number. These numbers will help you
identify the log when installing. It is very important to install these
logs exactly as instructed. Do not modify logs. Only use logs sup-
plied with fireplace.
Open louvers, remove screen, unlock door latches and open glass
door. See steps 1 and 2 of Removing Glass Door, page 20. Install
logs according to instructions for fireplace model numbers.
1. Place log #1 (rear log) on top of grate. Make sure the notches
in the bottom of the log fit over the grate (see Figure 40).
1
Figure 40 - Installing Log No. 1