Wiring diagram, Operating fireplace, Fireplace installation – Desa (V)T32EN-A Series User Manual

Page 23: Wiring diagram operating fireplace, Wall switch installation, Optional remote control installation (model wrc), Continued, For your safety read before lighting

Advertising
background image

23

23

www.desatech.com

116647-01A

Figure 46 - Installing the WRC Remote Receiver

Fireplace

Receptacle

Remote Control

Receiver

Extension Cord

Ignition

Module Plug

Figure 47 - Installing Battery into Back of Handset

Pull to Remove

Insulation Tab

Battery Cover

12 Volt Battery

Back of

Handset

WALL SWITCH INSTALLATION

The installation of a wall switch allows you to activate the gas

control valve and turn the fireplace on and off. The wall switch

is to be connected to the incoming 120 volt regular household

wiring that supplies the electricity to the fireplace.

OPTIONAL REMOTE CONTROL
INSTALLATION (Model WRC)

Note:

If using optional wireless hand-held remote control, the wall

switch must be in the ON position to be operational. The remote control

then becomes the switching mechanism for fireplace operation.
1. Open lower louver panel.
2. The WRC model receiver does not require a battery. The

receiver can be installed by first plugging the short extension

cord into the fireplace receptacle. Then plug the receiver unit

into the extension cord. Finally plug the ignition module plug

into the receiver unit (see Figure 46).

3. Activate the remote handset battery by removing the insulating

tab on the back of the handset (see Figure 47). The battery is

included pre-installed.

4. Once the battery is activated the unit is ready to use.
5. Close lower louver panel.

FIREPLACE INSTALLATION

Continued

EV2

EV1

ORANGE

IGNITOR LEAD

GREEN

PILOT

TRANSFORMER

IS1070

B

SYNETEK CONTROLS IN

C

24V AC

E4

E2

E3

E6

RED

E8

E12

BLUE

120V AC

GROUND

BLACK

WHITE

WIRING DIAGRAM

OPERATING FIREPLACE

FOR YOUR SAFETY

READ BEFORE LIGHTING

WARNING: If you do not follow these instructions

exactly, a fire or explosion may result causing property

damage, personal injury or loss of life.

A. This appliance is equipped with an ignition device which

automatically lights the pilot. Do not try to light the pilot

by hand.

B. BEFORE LIGHTING smell all around the appliance area

for gas. Be sure to smell next to the floor because some gas

is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

• Do not try to light any appliance.

• Do not touch any electric switch.

• Do not use any phone in your building.

• Immediately call your gas supplier from a neighborʼs

phone. Follow the gas supplierʼs instructions.

• If you cannot reach your gas supplier, call the fire

department.

C. Do not use this appliance if any part has been under water.

Immediately call a qualified service technician to inspect

the appliance and to replace any part of the control system

and any gas control which has been under water.

Advertising
This manual is related to the following products: