Datalogic Scanning DS1500 - Manual (Page 35)

INSTALLATION
2
2.6 TYPICAL LAYOUTS
The following typical layouts refer to system hardware configurations. Dotted lines in
the figures refer to optional hardware configurations within the particular layout.
These layouts also require the correct setup of the software configuration
parameters. Complete software configuration procedures can be found in the Guide
To Rapid Configuration
in the WinHost Help On Line.
2.6.1 Point-to-Point
In this layout the data is transmitted to the Host on the main serial interface. Host
Mode programming can be accomplished either through the main interface or the
Auxiliary interface.
In Local Echo communication mode, data is transmitted on the RS232 auxiliary
interface independently from the main interface selection.
When On-Line Operating mode is used, the scanner is activated by an External
Trigger (photoelectric sensor) when the object enters its reading zone.
Terminal Host
DS1500
3
1
2
Main serial interface
Auxiliary serial interface (Local Echo)
External Trigger (for On-Line mode)
1
2
3
Figure 18 – RS232 Point-to-Point Layout
NOTE
The Auxiliary RS232 interface is only available when the main
interface is RS232.
23