ADLINK PXI-3950 - Manual (Page 53)

Getting Started 39
PXI-3950
User’s Manual
3.7 Setting PXI-3950 Boot Devices
The PXI-3950 controller by default boots up from the SATA hard
drive. However, you can also set a USB device or a CF card as the
boot device in BIOS. Please follow the instructions below to set
the boot device of PXI-3950.
Boot from SATA hard drive
X Make sure the bootable SATA hard drive is installed in the
hard drive bracket.
X Power on the PXI-3950 and enter BIOS to modify the set-
ting of boot device as following:
Z [Boot] » [Hard Disk Drives] » [1st Drive]
Z [Boot] » [1st Boot Device] » [SATA:XX]
X Save the change
X Reboot the system
NOTE: NOTE:
If there is a CF card installed, you will see 1st Drive and
2nd Drive shown. Please recognize the bootable SATA
hard drive according the model name comes after the
xth Drive on the screen and set it to 1st Drive.
NOTE: NOTE:
“SATA:XX” refers to the model name selected in last
step.