ADLINK cPCI-3965 - Manual (Page 19)

Specifications 5
cPCI-3965
2 Specifications
2.1 cPCI-3965 SBC Specifications
CompactPCI®
Standards
• PICMG® 2.0 CompactPCI® Rev. 3.0
• PICMG® 2.1 Hot Swap Specification Rev.2.0
Mechanical
• Standard 3U CompactPCI®
• Board size: 100mm x 160mm
• Single slot (4HP, 20.32mm); Dual slot (8HP, 40.64mm) width
• CompactPCI® connectors with J1, J2
Processor
• µFC-PGA Intel® Core™2 Duo 2.2GHz (T7500),
4MB L2 cache, FSB 800MHz
• µFC-BGA Intel® Core™2 Duo 1.6GHz (L7500),
4MB L2 cache, FSB 800MHz
• µFC-BGA Intel® Core™2 Duo 1.06GHz (U7500),
2MB L2 cache, FSB 533MH
• µFC-PGA Intel® Celeron® 2.0GHz (550),
1MB L2 cache, FSB 533MHz
• Passive heatsink
Chipset
• Intel® GME965 Memory Controller Hub (MCH)
• Intel® ICH8M I/O Controller Hub (ICH)
Host Memory
• Dual channel DDR2-667 unbuffered non-ECC memory
• Two SO-DIMM sockets (stacked type)
• Maximum up to 4GB capacity
CompactPCI
Bus
• PCI 32bit/ 33MHz; 3.3V, 5V universal V I/O
• Supports operation in system slot only
Gigabit
Ethernet
• Two PCI-Express x1 Intel® 82573L Gigabit Ethernet
controllers
• Two egress 10/100/1000BASE-T ports, one port is
configurable to J2 (RTM) by software setting
Graphics
• GMA X3100 integrated in GME965 GMCH
• Shared system memory up to 384 MB
• One analog RGB port on front panel with up to 32bit,
2048x1536 resolution@ 75Hz
• One DVI-D port on front panel (8HP version only)
Serial Port
• Up to two 16C550 compatible RS-232 serial ports from
Super I/O IT8712F
• One RJ-45 port on front panel, one DB-9 port on rear panel
Storage
Interface
1
• CompactFlash Type II socket onboard
• 2.5” SATA HDD connector onboard (8HP version only)
• Two 7-pin SATA signal connectors on RTM