ADLINK cPCIS-ET2600 Series - Manual (Page 43)

Power Supply Unit
• 37
•
Noise & Ripple: 60 mV@5V and 3.3V output; 120mV@.± 12V
output.
•
OVP: Built-in at all outputs.
•
Adjustability: Available at VO1, 2 & 3.
•
Output Trim: Electrical trim available at VO1/VO2 [ADJ #].
•
Remote Sensing: Available at VO1, VO2 & VO3.
• Hot-Swap:
Available.
•
N+1 Redundancy: Installed with internal OR-ing diodes at all outputs
for N+1 redundancy operation.
• Current
Sharing: Third-wire current sharing at VO1,2 &3.
•
Power OK Signal: Available for all output.
•
Over Current Protection: Installed at each rail.
•
Overload Protection: Fully protected against output overload or short
circuit. Typical 120% max. load.
Output power versus temperature T
A
at V
i nom