ADLINK Express-HRR - Manual (Page 37)

Express-HRR Reference Manual 33
Chapter 4 BIOS Setup
Introduction
This section assumes the user is familiar with general BIOS Setup and does not attempt to describe the BIOS
functions. Refer to BIOS Setup Menus in this chapter for a map of the BIOS Setup settings. If ADLINK has
added to or modified any of the standard BIOS functions, these functions will be described.
Entering BIOS Setup (VGA Display)
To enter BIOS Setup using a VGA display for the Express-HRR:
1. Turn on the VGA monitor and the power supply to the Express-HRR.
2. Start Setup by pressing the [Del] key, when the following message appears on the boot screen.
Hit <Del> if you want to run SETUP
3. Use the <Enter> key to select the screen menus listed in the Opening BIOS screen.
4. Follow the instructions at the bottom of each screen to navigate through the selections and modify any
settings.
OEM Logo Screen (Splash Screen)
The Express-HRR BIOS supports a graphical logo screen, which can be customized by the user and
displayed when enabled through the BIOS Setup Utility. The graphical image can be a company logo or any
custom image the user wants to display during the POST process.
Logo Image Requirements
Please contact your ADLINK Sales Representative for more information on OEM Logo Screen
requirements.
NOTE The Quiet Boot feature must be set to Enabled in the Boot settings of BIOS Setup for
the system to recognize the OEM Logo Screen.