ADLINK Express-HRR - Manual (Page 41)

Chapter 4 BIOS Setup
Express-HRR Reference Manual 37
• Intel TXT (LT) Configuration
Intel Trusted Execution Technology Configuration
Intel TXT support only can be enabled/disabled if SMX is enabled and must enable the VT support
prior to TXT.
Secure Mode Extensions (SMX) [Disabled]
Intel TXT (LT) Support [Disabled]
• PCH-FW Configuration
♦ ME FW Version X.X.XX.XXXX
♦ ME Firmware Mode Normal Mode
♦ ME Firmware Type Full Sku Firmware
♦ ME Firmware SKU XMB
• Intel Anti-Theft Technology Configuration
♦ Intel Anti-Theft Technology [Disabled; Enabled]
♦ Intel Anti-Theft Technology Recovery [3]
♦ Enter Intel AT Suspend Mode [Disabled; Enabled]
• AMT Configuration
♦ Intel AMT [Disabled; Enabled]
• USB Configuration
♦ USB Devices:
• 2 Hubs
♦ Legacy USB Support [Enabled; Disabled]
♦ EHCI Hand-Off [Disabled; Enabled]
♦ USB Hardware delays and Time outs
• USB transfer time-out [1 sec; 5 sec; 10 sec; 20 sec]
• Device Reset Timeout [10 sec; 20 sec; 30 sec; 40 sec]
• Device power-up delay [Auto; Manual]
• ADT 7490 H/W Monitor
♦ Smart Fan Mode Configuration
• Fan1 Smart Fan Mode [Manual Mode; Auto Mode (Module); Auto Mode (ADT 7490); Auto
Mode (CPU)]
• Fan1 expect PWM Output [255]
• Fan2 Smart Fan Mode [Manual Mode; Auto Mode (Module); Auto Mode (ADT 7490); Auto
Mode (CPU)]
• Fan2 expect PWM Output/DC Voltage [255]
♦ Module temperature : +XX C
♦ ADT4790 temperature : +XX C
♦ CPU temperature (By PECI) : +XX C
♦ Module Fan1 Speed (In Module) : N/A
♦ Module Fan2 Speed: (In Carrier) : XXXX RPM
♦ Vtt : +X.XXX V