ADLINK Express-HRR - Manual (Page 45)

Chapter 4 BIOS Setup
Express-HRR Reference Manual 41
♦ USB Configuration
• EHCI1 [Enabled; Disabled]
• EHCI2 [Enabled; Disabled]
♦ PCI Express Configuration
• Target Link Speed [GEN1; GEN2]
• PCIE Ports 1-4 Configuration [Four X1 Ports; One X4 Port]
• PCI Express Root Port 1 (Main Switch) [Disabled; Enabled]
• PCI Express Root Port 2 [Disabled; Enabled]
• PCI Express Root Port 3 [Disabled; Enabled]
• PCI Express Root Port 4 [Disabled; Enabled]
• PCI Express Root Port 5 [Disabled; Enabled]
• PCI Express Root Port 6 [Disabled; Enabled]
• PCI Express Root Port 7 [Disabled; Enabled]
• PCI Express Port 8 is assigned to LAN
BIOS Boot Setup Screen
Figure 4-4. BIOS Boot Setup Screen
Express-HRR REV : XXX
Boot Configuration
Set Boot Priorities
CSM16 Module Version XX.XX
Version X.XX.XXXX. Copyright (C) 20XX American Megatrends, Inc.
Express-HRR_BIOS_Boot_a
Main Advanced Chipset Boot Security Save & Exit
Setup Prompt Timeout 1
Quiet Boot [Disabled]
Bootup NumLock State [On]
Option ROM Messages [Force BIOS]
GateA20 Active [Upon Request]
Interrupt 19 Capture [Enabled]
1st Boot [CD/DVD]
2nd Boot [Hard Disk : Xxxxxxxx]
3rd Boot [USB Floppy]
4th Boot [USB CD/DVD]
5th Boot [USB Hard Disk]
6th Boot [USB Key]
7th Boot [Network]
8th Boot [UEFI]
Hard Drive BBS Priorities
[Setting Description]
: Select Screen
: Select Item
+/- : Change field
F1 : General Help
Enter : Select
F2 : Previous Values
F3&F9 : Optimized Defaults
F4 : Save & Exit
F10 : Save & Reset
ESC: Exit