ADLINK ETX-PVR - Manual (Page 38)

Chapter 3 Hardware
32 Reference Manual ETX-PVR
LVDS Interface
The CPU provides direct LVDS outputs, which support a single channel 18-bit LVDS interface with three
signal lines. The N455 CPU provides digital LVDS resolution up to 1280x800, and the D525 CPU provides
resolutions up to 1366x768.
Table 3-6 describes the pin signals of the X3 ETX interface connector.
NOTE The necessary voltages to drive a flat panel are not supplied through the J3 connector
on the ETX-PVR module. The required drive voltages for the flat panel must be
designed into the customer’s baseboard and supplied from the ATX or AT power
supply to provide drive voltages for the LVDS connector to the flat panel.
Table 3-6. Complete X3 Interface Pin Signal Descriptions (J3)
J3
Pin # Signal Description
1, 2 GND Ground
3 Red Red – This is the Red analog output signal to the CRT.
4 Blue Blue – This is the Blue analog output signal to the CRT.
5 HSYNC Horizontal Sync – This signal is used for the digital horizontal sync output
to the CRT.
6 Green Green – This is the Green analog output signal to the CRT.
7 VSYNC Vertical Sync – This signal is used for the digital vertical sync output to the
CRT.
8 DDCK Display Data Channel Clock – This signal line provides the data clock signal
to the Memory Hub from the monitor. This is part of the Plug and Play
standard developed by the VESA trade association.
9 NC Not Connected
10 DDDA Display Data Channel Data – This signal line provides information to the
Memory Hub about the monitor type, brand, model. This is part of the Plug
and Play standard developed by the VESA trade association.
11 NC Not Connected
12 NC Not Connected
13 NC Not Connected
14 NC Not Connected
15, 16 GND Ground
17 NC Not Connected
18 NC Not Connected
19 NC Not Connected
20 NC Not Connected
21, 22 GND Ground
23 NC Not Connected
24 NC Not Connected
25 NC Not Connected
26 NC Not Connected
27, 28 GND Ground