ADLINK ETX-PVR - Manual (Page 47)

Chapter 3 Hardware
ETX-PVR Reference Manual 41
Note: The shaded areas denote power or ground. The * symbol indicates the signal is Active Low.
75 NC Not Connected
76 PIDE_D11 Primary Disk Data 11 – Refer to J4, pin-58 for more information.
77 NC Not Connected
78 PIDE_D4 Primary Disk Data 4 – Refer to J4, pin-58 for more information.
79 NC Not Connected
80 PIDE_D10 Primary Disk Data 10 – Refer to J4, pin-58 for more information.
81,
82 VCC DC Power – +5 volts +/-5%
83 NC Not Connected
84 PIDE_D5 Primary Disk Data 5 – Refer to J4, pin-58 for more information.
85 NC Not Connected
86 PIDE_D9 Primary Disk Data 9 – Refer to J4, pin-58 for more information.
87 NC Not Connected
88 PIDE_D6 Primary Disk Data 6 – Refer to J4, pin-58 for more information.
89 NC Not Connected
90 CBLID Cable ID Select – Used to detect the presence of an 80 conductor IDE cable
on the primary IDE channel. This allows BIOS or system software to
determine if it is necessary to enable the high-speed transfer modes (DMA66
or DMA100).
91 RXD- Half of Ethernet Analog Twisted Pair Receive Differential Pair – This pin and
pin-93 make up the Receive twisted pair and receive the serial bit stream on
the Unshielded Twisted Pair Cable (UTP).
92 PIDE_D8 Primary Disk Data 8 – Refer to J4, pin-58 for more information.
93 RXD+ Part of Ethernet Analog Twisted Pair Receive Differential Pair – Refer to pin-
91 for more information.
94 NC Not Connected
95 TXD- Half of Ethernet Analog Twisted Pair Transmit Differential Pair – This pin
and pin-97 make up the Transmit twisted pair and transmit the serial bit
stream on the Unshielded Twisted Pair Cable (UTP).
96 PIDE_D7 Primary Disk Data 7 – Refer to J4, pin-58 for more information.
97 TXD+ Part of Ethernet Analog Twisted Pair Transmit Differential Pair – Refer to
pin-95 for more information.
98 HDRST* Hard Reset – Low active hardware reset (RSTDRV inverted)
99 GND Ground
100 GND Ground
Table 3-8. Complete X4 Interface Pin Signal Descriptions (J4) (Continued)