7 internal usb connector, 8 sata connectors, 9 backboard to system pcb connector – ADLINK MXC-6000 Series User Manual
Page 44: Internal usb connector, Sata connectors, Backboard to system pcb connector
Advertising
32
Introduction
1.7.7
Internal USB Connector
The MXC-6000 series controller provides an internal USB connec-
tor on the back board PCB.
1.7.8
SATA Connectors
The MXC-6000 provides 2 SATA ports, supporting up to 2nd Gen-
eration (3GB/s) transfer rate. The SATA host controller can be set
to operate in IDE or AHCI mode in BIOS.This SATA connector is
designed to support a 2.5 inch hard disk drive (HDD) or solid state
disk (SSD). The HDD or SSD must be installed into the SATA con-
nector with a HDD bracket. Please refer to Section 3.1 for installa-
tion of a 2.5 inch HDD or SSD.
1.7.9
Backboard to System PCB Connector
This connector connects the backboard to a golden fin-
ger-equipped mainboard PCB.
Advertising