Delta RMC101 - Manual (Page 542)

RMC100 and RMCWin User Manual
5-292
237 Storage of parameters to Flash failed
238 Storage of splines to Flash failed
239 Steps per Rev and Position Units per Rev must not be zero
240 Reserved parameters must be zero
241 Maximum Steps per Millisecond parameter out of range
242 Invalid Address Used in Add (+) or Subtract (-) Command
243 Step Number in Teach (t) or Function (,) Command Out of Range
244 No Axes Selected for Use by the Function (,) Command
245 Function in the Function (,) Command Out of Range
246 The Accel Field Must Be Zero in the Command Issued
247 Invalid Screen Number in the Display LCD Screen ($) Command
250 Move would cause discontinuity
251 SSI transducer overflow
252 SSI transducer noise
253 Reserved command parameters must be 0
260 The acceleration or deceleration ramp is too slow
270 The command acceleration is invalid
271 The command deceleration is invalid
280 Both sync bits cannot be set in the "Mode" word
281 A synchronized axis is not initialized
282 Incompatible sync mode words
283 Synchronized axis was incorrectly dropped
284 Cannot issue a 'Z' or 'z' command to a synchronized axis
285 Cannot use synchronization with speed control
286 Cannot home an axis while synchronized
290 Gear ratio denominator is zero
291 Gearing and synchronization illegal in open loop
292 Invalid gear master selected
300 Pressure set A cannot be less than pressure set B
301 Command pressure cannot be less than pressure set A
302 Command pressure cannot be less than pressure set B
303 Axis reached command position while regulating pressure
304 No initialized pressure axis is assigned for monitoring pressure
305 Attempt to enter pressure immediately failed
306 Pressure Control went outside position limits
310 "Event Step Edit" indices are invalid
320 Too many spline points. Point not added.
321 Point cannot be added during calculation
322 The spline interval cannot be set below 5