Display Devices SE-B6-10 Soffit Series User Manual
Page 4
01-07
4
tel: 303.412.0399
www.displaydevices.com
fax: 303.412.9346
5880 Sheridan Blvd., Arvada, Colorado 80003
9.)
Verify the mount position front-to-back and side-to-side. Adjust the position of the mount if
required. Front-to-back: loosen the (4) 3/4” bolts on the “L” brackets in the side Unistrut
channels. Move the mount/cross rails to the appropriate position and tighten the hardware in
the side channels. (THESE ARE UNISTRUT NUTS AND WILL TURN/UNLOCK WHEN
LOOSENED – BE SURE THEY ROTATE WHEN TIGHTENED AND LOCK INTO CHANNEL)
10.)
Install mount/projector or lift/projector according to the manufacturer‟s procedure.
11.)
Plumb AC power to the power supply. Remove a knock-out and secure with strain relief.
Power input is on the power supply with an IEC connector.
12.)
Plug your projector into the switched power outlet inside on the power supply.
13.)
Remove another knock-out to route your projector signal/control cables. Secure with strain
relief.
14.)
Remove blue film from glass then position in projection port. Add top hold down strip and
(2) 14”-20 nuts. Tighten nuts until glass is snug between gaskets.
15.)
Turn on the power supply, then turn on the projector and adjust your projected image to the
screen.
16.)
See the temperature controller section below to set fan temperature settings.
17.)
Finish soffit / wall around enclosure.