Elenco Snap Circuits SnapMicro ® I Standard User Manual
Page 33
32
This program is 2 bytes less and much easier to read with less jumping and only one label. Of course
the comments will help later when you edit this for different applications.
It is a good practice to build up a library of
small sub routines and then use them in
different applications when they are
needed. The more information stored in
the library the easier it will be to import
and use these routines later.
If you run a simulation of this program it
will take a long time for the b0 variable to
reach 127. Open the variable panel,
pause the program, and double click on
the b0 to change it to 115.
Restart the program and watch the b0
variable loop between 110 and 127. In
simulation the sound command does
not play the frequency. Instead a ‘Beep’
is produced to let you know a sound
command was executed. After down
loading the real sounds will be heard.
Save program to your library then
download it to play special effect sound.
Close file.
1.Pause & Start Button
2.Double Click b0
3.Edit to 115