ENMET SPECTRUM - Manual (Page 11)

SPECTRUM Series ENMET Corporation
7
3.0 Maintenance 3.0 Maintenance 3.0 Maintenance 3.0 Maintenance
3.1 Maintenance Menu
From the operational display, press the OPTION pushbutton four times; "go SETUP" is displayed. This is the
entrance to the maintenance menu. The maintenance menu flow diagram is shown in Figure 3.
Figure 3: Maintenance Menu Flow Diagram
go SETUP
INVALID
To Operational
Display
From Operational Display
Changes digit indicated by underscore cursor
Locks underscored digit and moves cursor
S
VALID
Exit To Operational Display
O S
O
run ZERO
S
S
AIR SET? To Exit
z30:0.0v
C-FAULT
To Operational Display
VALID
INVALID
O
O
run CAL
S
z30:0.0v No Function
AIR SET? To Exit
S
GAS=XXXX To Exit
S
GAS SET? To Exit
S
XXX:Y.Yv
C-FAULT
To Operational Display
VALID
INVALID
O
O or S
O
O
O
set BATT
S
Alk/Lith NiCad
O
S S
Key=0000
O
S
O
set KEY
S
new=XXXX
KEY=0000
Changes digit indicated by underscore cursor
Locks underscored digit and moves cursor
O
S
O or S
To Exit
INVALID
O
S
set ALM
O or S new=XXXX
ALM=0000
Changes digit indicated by underscore cursor
Locks underscored digit and moves cursor
O
S
To Exit To Exit
O = Option Switch
S = Select Switch