ENMET SPECTRUM - Manual (Page 5)

SPECTRUM Series ENMET Corporation
1
1.0 Introduction 1.0 Introduction 1.0 Introduction 1.0 Introduction
The SPECTRUM is a small portable battery operated single channel gas detection instrument. Depending on the
sensor supplied with the instrument, it can detect one of a number of potential target gases. An electrochemical cell
detects the gas, and the gas concentration is displayed on an LCD. Audio and visual alarms occur when the target gas
concentration exceeds a preset alarm point. At relatively low concentrations of the gas, an alarm can be
acknowledged, which results in the temporary cessation of the audio alarm. Operation and maintenance procedures
are managed with three pushbutton switches. Appropriate warnings are issued when remaining battery energy is low.
For ruggedness and EMF protection, the instrument enclosure is an aluminum die casting. The instrument is shown in
Figure 1.
Several sensors have been qualified for target gases, the list is found in Table 1.
A CO SPECTRUM, for the detection of carbon monoxide, is described in a separate manual.
N OTE : All specifications stated in this manual may change without notice.
1.1 Unpack
Unpack the SPECTRUM and examine it for shipping damage. If such damage is observed, notify both ENMET
customer service personnel and the commercial carrier involved immediately.
Regarding Damaged Shipments
N OTE : It is your responsibility to follow these instructions. If they are not followed, the carrier will
not honor any claims for damage.
This shipment was carefully inspected, verified and properly packaged at our company and delivered to the
carrier in good condition.
When it was picked up by the carrier at ENMET , it legally became your company’s property.
If your shipment arrives damaged:
•
Keep the items, packing material, and carton “As Is.” Within 5 days of receipt, notify the carrier’s local
office and request immediate inspection of the carton and the contents.
• After the inspection and after you have received written acknowledgment of the damage from the carrier,
contact
ENMET Customer Service for return authorization and further instructions. Have your Purchase
Order and Sales Order numbers available.
ENMET either repairs or replaces damaged equipment and invoices the carrier to the extent of the liability
coverage, usually $100.00. Repair or replacement charges above that value are your company’s responsibility.
The shipping company may offer optional insurance coverage. ENMET only insures shipments with the
shipping company when asked to do so in writing by our customer. If you need your shipments insured, please
forward a written request to
ENMET Customer Service.
Regarding Shortages
If there are any shortages or questions regarding this shipment, please notify ENMET Customer Service within 5 days
of receipt at the following address:
ENMET Corporation
680 Fairfield Court
Ann Arbor, MI 48108
734-761-1270 734-761-3220 Fax
1.1.1 Check Order
Check, the contents of the shipment against the purchase order. Verify that the SPECTRUM is received as ordered.
Each SPECTRUM is labeled with its target gas. If there are accessories on the order, ascertain that they are present.
Check the contents of calibration kits. Notify ENMET customer service personnel of any discrepancy immediately.
1.1.2 Serial Numbers
Each SPECTRUM is serialized. These numbers are on tags on the equipment and are on record in an ENMET
database.