Digi RCM4000 - Manual (Page 85)

User’s Manual 79
It is recommended that you allow for an “exclusion zone” of 0.04" (1 mm) around the
RCM4000 in all directions when the RCM4000 is incorporated into an assembly that
includes other printed circuit boards. An “exclusion zone” of 0.08" (2 mm) is recom-
mended below the RCM4000 when the RCM4000 is plugged into another assembly.
Figure A-2 shows this “exclusion zone.”
Figure A-2. RCM4000 “Exclusion Zone”
J3
Exclusion
Zone
1.84
(47)
0.51 (16)
0.51 (16)
2.50
(63)
1.92
(49)
0.08
(2)
0.08
(2)
2.42
(61)