EXFO ETS-1000 - Manual (Page 146)

Specifications
138 ETS-1000
Specifications Values
Tests according to RFC 2544 Available tests: Throughput, Frame
Loss, Back-to-Back, Latency.
Frame size: 64, 128, 256, 512, 1024,
1280, 1518 bytes,and user-defined.
IP-tests Ping, Traceroute, DNS lookup,
TCP-client.
Loopback Loopback at the Physical (PHY), Data
Link (MAC),and Network (IP) layers
with VLAN support and fields swapping
capability.
Cable test Testing a copper cable for break,
short-circuit, estimating the distance to
the break point.
BERT Test is used to determine the major
data link quality parameter - bit error
rate.
Packet jitter Packet jitter measurements, results are
displayed as a table and graph. The test
is used to estimate the tested network
capability to transmit the
latency-sensitive traffic.
Remote control Remote control of the analyzer in the
following modes:terminal, via TELNET
protocol, via WWW-interface.
With remote control running the tests,
parameters setup,getting test results
are supported.