Event log, Date> <time> <sender> <message – EXFO ETS-1000 User Manual
Page 37
Setting up your Unit
Ethernet Tester Analyzer
29
Unit Setup
Event Log
Event log provides events messages display in the ETS-1000. Setup Log
menu and also in console terminal by connection to the device via
USB-interface and by remote control via TELNET protocol.
Logged events are listed below:
start/stop of the test;
Loopback mode is switched on/off;
change of connection state;
remote test is running;
device is switched on/off;
low battery.
If one of these events occurred, the following message will be displayed in
the console terminal/Log menu.
<date> <time> <sender> <message>
For example, if you switch on Loopback mode at the 2nd layer on port B,
the following message will be displayed:
By default the function of messages displaying via USB interface and via
TELNET protocol is switched off. To switch on/off use log on/off remote
control command.