EXFO ETS-1000 - Manual (Page 160)

Remote Control Commands
152 ETS-1000
ctraf rate int
set framed rate value (in % by
de-fault)
ctraf rate int unit
set framed rate value (kbps,
Mbps, %)
ctraf frame int set frame size
BERT
bert header src mac
XX:XX:XX:XX:XX:XX
set source UDP-port number
bert header src ip i.i.i.i set source IP address
bert header src udp text set source UDP-port number
bert header dst mac
XX:XX:XX:XX:XX:XX
set destination MAC address
bert header dst ip i.i.i.i set destination IP address
bert header dst udp text set destination UDP-port
number
bert header vlan enabled off/on enable/disable VLAN parameter
bert header vlan id text set VLAN identifier
bert header vlan priority text set traffic priority
bert header precedence text set frame priority
bert header tos 0000 / 1000 / 0100 /
0010 / 0001
set type of service for the
packet
bert topology port tx a/b set data transmitting port
bert topology port rx a/b set data receiving port
bert level 1/2/3/4 layer of OSI model at which
BERT will be performed
Command Operation