Setting test parameters, Parameters of the throughput test – EXFO ETS-1000G User Manual
Page 42
Preparing RFC 2544 for Analysis
32
ETS-1000G
Setting Test Parameters
Setting Test Parameters
There are two ways to set values of test parameters for making
an analysis:
1. Select standard settings in compliance with RFC 2544. To do so, select
RFC-2544 > Setup and press
(By default).
2. Set parameters manually according to the directions given in the
subsequent sections.
To optimize the speed and to increase the efficiency of making an analysis,
ETS-1000G provides an option to change the standard values of test
parameters (defined by RFC 2544).
Test results are represented in the tabular and graphical forms according to
RFC 2544 recommendation.
Parameters of the Throughput Test
Enabled
Enabling/disabling the throughput analysis.
Rate (L1)
A raw data rate value (L1) that is specified in percentage
terms (
), Kbps (
) or Mbps (
).