EXFO ETS-1000G - Manual (Page 74)

ET–Discovery
64 ETS-1000G
To obtain data on the remote device and ensure that the
Loopback mode can be enabled, follow the procedure below:
1. Connect ETS-1000G to the network according to the diagram shown in
the previous page.
2. Open the Network Parameters menu, specify the port's IP address or
make sure that the device has received the correct IP address via
DHCP.
3. Open the ET Discovery menu.
4. Specify the IP address of the remote device in the IP address field.
5. Press (Detect). If the function has been executed successfully, the IP
address, the name and the MAC address of the remote device will be
displayed on the screen. The Loopback menu item will become
available for editing.
6. 6. Select the loopback layer using , , .
Note: The data are transmitted over UDP. Destination port: 32 792. Source port: 32
793.
IP An IP address of the remote device.
Loopback Select the loopback layer:

- Disable the Loopback mode.

- Enable the data link layer loopback.

- Enable the network layer loopback.

- Enable the transport layer loopback.