EXFO ETS-1000G - Manual (Page 79)

TCP/IP Tests
10 Gigabit Ethernet Analyzer 69
Traceroute
Traceroute
The Traceroute tool is used for determining data routes and allows
diagnosing the availability of intermediate network devices. During the test
a sequence of frames is sent to the specified node and the system displays
information about all the intermediate routers through which the data have
been relayed on the way to the end node.
To perform the test, follow the procedure below:
1. Connect the device to the network under test according to the diagram
shown on this page.
2. Set up a network connection (refer Network Parameters on page 103).
3. Open the Traceroute menu.
4. Set up the test parameters in the Traceroute Setup menu.
(Start) Start the test.
(Setup) Open the Traceroute Setup menu.
(Save/Load) Open the menu for saving test results.