EXFO PM-1100 Optical Power Meter - Manual (Page 39)

Operating the Optical Power Meter
Optical Power Meter 29
Recalling Acquisition Data
3. Using the up/down arrows, scroll to the register number you want to
view.
4. Press ENTER. The selected register will be displayed.
Note: A dashed line with no wavelength indicates an empty register. A dashed
line along with a wavelength indicates a reading below range.
“++++++++” indicates a reading above range.
³
To view another register, press ENTER. The next register will be
suggested (flashing). If necessary, scroll (up/down arrows) to the
desired register number. Press ENTER again to display the register.
Note: You can press ENTER repeatedly to quickly scan the measurements in
adjacent registers.
³
To exit the Recall menu, press Recall.
nm
Measurement
Wavelength at which the
measurement was taken
A small “M” indicates you
are in Memory Recall mode
Measurement unit
nW
A delta symbol indicates
a relative value in watts