EXFO PM-1100 Optical Power Meter - Manual (Page 43)

Operating the Optical Power Meter
Optical Power Meter 33
Customizing Your Optical Power Meter
Customizing the Shortlist of Wavelengths
The Optical Power Meter detector port can measure optical power at many
wavelengths. The accepted wavelengths (spectral range, see Technical
Specifications on page 65) depend on the type of detector with which the
Optical Power Meter is equipped. Store the wavelengths you use the most
often in a shortlist so you can quickly access them by pressing
λ
during a
test session. The shortlist includes up to 20 wavelengths.
To add a wavelength to the shortlist:
1. Press Setup.
2. Scroll (left/right arrows) to LAMBDA.
3. Scroll (up/down arrows) to Add.
4. Press ENTER. A wavelength will be suggested, first digit flashing.
5. Use the up/down arrows to change the flashing digit and the left/right
arrows to activate the next digit.
6. Once the digits are set, press ENTER.
7. To exit the Setup menu, press Setup.
You can scroll up or down
to see all the wavelengths
in the shortlist.