GoDEX EZ2050 series - Manual (Page 17)

13
3
Setting and Control for Operation Panel
3.2 Function buttons – introduction
FEED button
When you press the FEED button, the printer moves the label to the defined stop
position. If you are using continuous labels, pressing the FEED button will move label
stock until you release the button again. If you are using individual labels, pressing
the FEED button will move only one label. If the label does not stop at the correct
position, you need to run the auto-detection function on the label stock (see
Section 3-5).
PAUSE button
Pressing the PAUSE button while the printer is in standby mode will set the printer to
pause mode. In this mode, the printer can receive commands, but it can only
process them when it is reset to standby mode. Pressing the PAUSE button again will
reset the printer to standby mode.
Pressing the PAUSE button during printing will interrupt printing. When the PAUSE
button is pressed again, the printer resumes printing. Example: While a 10-label print
job is running, you press the PAUSE button to pause the printer. Two of the labels
have been printed. To resume printing and print the remaining eight labels, you
press the PAUSE button again.
CANCEL button
Pressing the CANCEL button during printing cancels a print job. The current print job
is cancelled. Example: While a 10-label print job is running, you press the CANCEL
button. Two of the labels have been printed. The print job is cancelled and the
remaining eight labels are not printed.
You can combine the FEED, PAUSE and CANCEL buttons in a number of ways to perform
different printer functions:
Function Button Beeps Description
Self test
+ Power On 3 beeps
Switch on the printer and keep the
button pressed until you hear 3 beeps.
Dump mode
+ Power
On
3 beeps

1
beep
After the self test, keep the button
pressed until you hear a beep.
Auto-
detection
+ Power On 3 beeps Switch on the printer and keep the
button pressed until you hear 3 beeps.
Factory
settings
+ +
Power On
2 x 2
beeps
Switch on the printer and keep the
and buttons pressed until you hear 2
beeps. This resets the printer to the factory
settings.
Download
mode
+ Power
On
1 beep
Switch on the printer and keep the
button pressed until you hear a beep. This
mode is for download of the firmware
only.
Settings
mode
3 beeps
Switch on the printer and keep the
button pressed for about 3-4 seconds,
until you hear 3 beeps.