GoDEX EZ2050 series - Manual (Page 18)

14
3
Setting and Control for Operation Panel
3.2 Settings mode
In settings mode, you can change different settings, such as the printing mode or media
type.
1. Switch on the printer and make sure that the POWER (Ready) LED lights up.
2. Press the PAUSE button and keep it pressed for about 3-4 seconds until you hear 3
beeps.
3. In settings mode, the buttons have the following functions:
: Minus / Enter
: Menu / Next
: Plus / Exit
Press the button to select the adjustment items; press the button or the
button to change the setting values.
4. To exit the settings mode, you need to go back to the beginning of setting mode
and decide whether to save the changes you have made or exit without saving.
Once you have saved or discarded your changes, the printer will switch back to
standby mode.
Press the
button and keep it pressed for about 3-4 seconds until you hear 3 beeps.
Blinking
Steady
DENSITY SPEED Description
Start / Exit
Setting mode
Exit
withou
t
saving
Save &
exit
DENSITY and SPEED lights
steady to indicator the strat
or the end of setting mode.
Darkness
Decre
ase
the
setting
value
Increas
e the
setting
value
DENSITY light flashes and
then blinks for each
pressing. The buzzer will
beep when the adjustment
reaches the maximum or
minimal.
Speed
Decre
ase
the
setting
value
Increas
e the
setting
value
SPEED light flashes and
then blinks for each
pressing. The buzzer will
beep when the adjustment
reaches the maximum or
minimal.