GoDEX EZ2050 series - Manual (Page 35)

31
5
Maintenance and Adjustment
5.1 Installing / removing the print head module
1. Open the printer
cover.
【 Note 】
Remember to switch off the
printer before removing the
print head module.
2. Pull out the print head
release lever as shown
in the illustration (1)
and turn it
anticlockwise to a top
right position (2).
2
1
3. Hold the print head
module at the front
and gently pull it out.
4. If you cannot remove
the module by gently
pulling it, use a
screwdriver as shown
in the illustration.
5. Hold the module at
the front and slide it
into the printer along
the guide rails. Firmly
press the module in so
the contacts are fully
connected.