GoDEX EZ2050 series - Manual (Page 9)

5
2
Printer Setup
5. Place the label roll on the label supply hub, pushing it right up to the printer housing.
(Do not apply too much pressure to avoid damaging the label stock.)
6. Fold the label roll guide back down and push it against the label roll.
【 Note 】
When moving the label roll guide, hold it only by the end that is attached to the bracket,
not by its top.
7. Load the label roll into the printer as shown in the illustration. Pass it through the
printer as indicated by the blue arrows.
1
2
3
8. Pass the label stock through the sensor and up to the tear-off plate.
【 Note 】
Remember to set the movable sensor to gap, black mark, or tag hole by changing the position of
the sensor with the adjustment wheel.