Labconco Protecto Downdraft Powder Station 3410025 - Manual (Page 10)

Chapter 3: Getting Started
Product Service 1-800-522-7658 6
3) Install both side shields by engaging the notches in each panel into the gap
between the front panel and the filter module. Ensure the side panel pin
engages the oversized holes on the edges of the work surface.
4) Plug the power cord into the filter module. The plug socket is located on
the top right rear corner of the station. The unit is ready for use.
Figure 3-3
Ensure the pins
go into the
oversized holes.